Kenwood Nexedge NX-740HV Transceiver Radio Base Station w/ KMC-35 Microphone

Description

Kenwood Nexedge NX-740HV Transceiver Radio Base Station w/ KMC-35 Microphone
Specifications
Key Features
NXDN Air Interface
AMBE+2 Vocoder for Natural Sounding Digital Voice
Operates in NXDN Digital Conventional and FM Analogue Modes, even on the same channel
Autosenses Received Mode (Digital or Analogue)
2 Zones - 16 Channels per Zone
50 Watts High-power model
True 6.25 kHz Channel Spacing Digital Operation
Includes Radio-to-Radio Mode (no repeater needed)
Supplied With
D.C. Cable
Yes
Fuse
Yes, 15 A
Instruction Manual
Yes, In English, Spanish & French
Microphone
Yes, KMC-30
Microphone Hanger
Yes
Mounting Bracket
Yes
Screw Set
Yes
PMR General Features
Blue colour LED
Yes
3-colour LED (Red, Orange, Green)
Yes
2-Tone Signalling
Yes
Busy Channel Lock-out
Yes
Compact Design
Yes
Companded Audio
Yes
DB-15 Accessory Connector
Yes; can also be programmed as 8 individual Accessory Ports
DTMF Function
Yes
Ease of Operating Use
Yes
Emergency Call Function
Yes
Emergency Key
Yes
Enhanced Kenwood Audio
Yes
Flash Upgradeable Firmware
Yes
FleetSync
Yes
Front-mounted Loudspeaker
Yes
GPS Compatible
Yes
Horn Alert/PA Function
Yes
Ignition Sense Input and Cable Option
Yes
Kenwood ESN (Electronic Serial Number)
Yes
Lone Worker Function
Yes
MDC-1200
Yes
Minimum-Volume Setting
Yes
Monitor Button
Yes
Multiple Scanning Function
Yes
Operator Selectable Tone
Yes
Programmable Function Keys
9 Programmable Function Keys
PTT Release Tone
Yes
QT (CTCSS) / DQT (digital)
Yes
Remote Stun/Kill
Yes
Selectable Microphone Gain
Yes
Talk Around
Yes
"Talk Back" Scanning Function
Yes
Time-Out Timer
Yes
Transceiver Password
Yes
Voice Guide Channel Confirmation
Yes, Choose from English, Spanish, Russian or Chinese
Wide-band Frequency Coverage
Yes
Windows PC Programming and /Tuning
Yes
Wired Cloning /Function
Yes
Nexedge Features
Alphanumerical Aliases
Yes - TX Only
Conference Group Call
Yes
CW (Morse Code) Message Function
Yes
Electronic Serial Number
Yes
FM Analogue Conventional Included
Yes
Individual Call
Yes
Late Entry
Yes
NXDN Conventional Included
Yes
NXDN Digital True 6.25kHz Channel Spacing
Yes
Paging Call
Yes
Radio Access Numbers (RAN)
Yes
Remote Monitoring
Yes
Site Roaming (Digital Conventional Mode)
Yes
Status Messaging
Yes
Zones
2
FleetSync Signalling Features
Paging Call Function
Yes
PTT ID Digital ANI
Yes
Selective Calling
Yes
Send GPS Data
Yes, From attached NMEA0183 GPS device
Applicable Standards
IP54
Yes
MIL-STD 810 C/D/E/F/G
Yes
Technical Specifications
Frequency Range - K Type
136 - 174 MHz
Number of Channels
32
Number of Zones
2
Channel Frequency Spread
38 MHz
Channel Spacing
Analogue : 12.5 kHz
Channel Spacing - Digital
6.25 kHz
Antenna Impedance - 50 Ohm
Yes
Antenna Connector
SO-239
Frequency Stability
± 2 ppm (-30 °C to + 60 °C)
Operating Temperature Range
-30 °C to + 60 °C
Operating Voltage
13.6 V DC ± 15%
Dimensions
160 x 43 x 122.6 mm
- Projections not included -
Weight (net)
1.1 kg
Receiver Specifications
Audio Output
4 Watt with less than 5% distortion
Intermodulation
Analogue: 65 dB
Selectivity (Analogue)
65 dB
Sensitivity
Digital: 0.28 µV
Sensitivity (Analogue) - EIA 12 dB SINAD
0.28 µV
Spurious Reponse Rejection (Analogue)
75 dB
Transmitter Specifications
RF Power Output
(High/Mid/Low): 50 W / 25 W / 5 W
FM Noise (EIA)
Analogue: 40 dB
Modulation Distortion
Less than 5%
Spurious Response (EIA)
70 dB
This is a Pneumatic Mast that extends 12' I believe it is classified as a 4 stage. Its compact length is approx. 5'6" and extends to 17'6". There is also a 3ft solid aluminum extension pole that attaches to the top so would be 8'6" - 20'6".  This was removed from a ParaSail boat and was used to lift the chute into the air flow allowing for boat launches rather than beach launches (Safer). This is a used pneumatic mast from a ParaSail Boat (Heavy Duty) that works as expected. it extends 12'. It is the mast only no compressor. simply air on to raise and open the valve to lower. Has a couple of slight paint marks and comes with a base plate and mid bracket attached. Without the 3' extension, it is 5'6" long and extends to 17'6" with the extension 8'6" - 20'6". I believe it is classified as a 4 stage.
There is some minor scratching (see photos) and paint brush marks, chipping of paint on mid bracket, all minor stuff and does not effect performance.  Not sure how it will need to be shipped but open to suggestions, I believe UPS ground will carry it but needs to be confirmed. Initial shipping plan is to wrap in cardboard and insert in a large tube?